Viking MI 632.1 Manuel D'utilisation page 111

Closing the panel:
Fold the panel (1) rearwards – do not
pinch any cables.
Fitting the cover:
0478 131 9936 B - EN
Fit the cover (1) onto the docking station
and allow it to engage – do not pinch any
cables.
9.3 Connecting the power cable to the
docking station
● Remove the docking station cover and
open the panel. ( 9.2)
Connect the connector of the power supply
unit (1) to the circuit board of the docking
station.
Guide the power cable through the cable
guide (1) on the panel.
● Close the panel. ( 9.2)
Press the power cable into the cable
guide (1) as illustrated and guide through
the strain relief (2) and the cable duct (3)
to the power supply unit.
● Close the docking station cover. (
9.4 Installation material
If the perimeter wire is not routed by the
specialist dealer, additional installation
material not included in the standard
equipment will be required to be able to
operate the robotic mower. (
9.2)
18.)
109