Publicité
Les langues disponibles
Les langues disponibles
Pull out the pegs (1), remove the docking
station (2) from the lawn with the power
supply unit connected, clean thoroughly
(with a moist cloth) and put into storage.
● Store the robotic mower together with
the docking station and the power
supply unit in the normal position and in
a dry, closed and dust-free room. Dock
the robotic mower in the docking
station. Make sure that the machine is
kept out of the reach of children.
● Protect the terminals of the perimeter
wire from environmental influences
(e.g. wrap with suitable insulating tape).
● Reinstall the docking station in the
same way as during initial installation –
in particular connect the right and left
perimeter wire ends on the correct
sides. (
9.9)
17. Standard spare parts
Mowing blade:
6309 702 0102
0478 131 9936 B - EN
Battery AAI 131:
for: MI 632, MI 632 C
6309 400 6511
Battery AAI 201:
for: MI 632 P, MI 632 PC
6309 400 6501
18. Accessories
Installation kits:
iKit S for mowing areas up to 500 m
6909 007 1011
iKit L for mowing areas from 2000 m
2
4000 m
6909 007 1012
Fixing pins AFN 075:
6301 007 1010
Perimeter wire ARB 501:
Length: 500 m
Diameter: 3,4 mm
0000 400 8625
Wire connector ADV 010:
6909 007 1090
Small-area module AKM 100:
6909 007 1016
Additional accessories are available for
the machine.
Further information is available from your
VIKING specialist dealer, on the internet
(www.viking-garden.com) or in the
VIKING catalogue.
For safety reasons, only
accessories approved by VIKING
may be used with the machine.
19. Minimising wear and
preventing damage
Important information on maintenance
and care of the product group
Robotic mower, battery powered
VIKING assumes no liability for material or
personal damage caused by the non-
observance of information contained in the
operating instructions, in particular with
2
regard to safety, operation and
maintenance, or which arise through the
2
–
use of unauthorised attachment or spare
parts.
Please always observe the following
important information for the prevention of
damage or excessive wear to your VIKING
machine:
1. Wearing parts
Some parts of the VIKING machine are
subject to normal wear even when used
properly and must be replaced in due time
depending on type and duration of use.
These include:
– Mowing blade
– Battery
2. Compliance with the information in
this instruction manual
The VIKING machine must be used,
maintained and stored with the care
described in this instruction manual. Any
damage caused by non-compliance with
the safety, operating and maintenance
instructions is the sole responsibility of the
user.
This applies in particular to:
– incorrect handling of the battery
(charging, storage),
155
Publicité
