Message:
2031 – Charging failure
Check charging contacts
Possible cause:
– Charging cannot be started
Remedy:
– Check the charging contacts on the
docking station and robotic mower and
clean if necessary – then confirm the
message with OK
Message:
2032 – Battery temperature
Outside temperature range
Possible cause:
– Temperature in battery during charging
too low or too high
Remedy:
– Allow the robotic mower to warm up or
cool down – observe permissible
temperature range of battery
Message:
2040 – Battery temperature
Outside temperature range
Possible cause:
– Temperature in battery when starting
mowing operation too low or too high
Remedy:
– Allow the robotic mower to warm up or
cool down – observe permissible
temperature range of battery (
0478 131 9936 B - EN
Message:
2050 – Adapt mowing plan
Extend active times
Possible cause:
– Active times have been
shortened/deleted or the mowing
duration has been extended – the
stored active times are insufficient for
the necessary mowing operations.
Remedy:
– Extend the active times (
shorten the mowing duration (
Message:
2060 – Mowing completed
Press OK to release
Possible cause:
– Mowing in secondary area successfully
completed
Remedy:
– Return the robotic mower to the mowing
area and dock to charge the battery
(
15.7)
Message:
2070 – GPS signal
No reception at edge
Possible cause:
– The entire edge of the mowing area is in
a dead spot
Remedy:
6.4)
– Repeat edge following (
– Contact a VIKING specialist dealer for a
detailed diagnosis
Message:
2071 – GPS signal
No reception at starting pt. 1
Possible cause:
– Starting point 1 is in a dead spot
Remedy:
– Change the position of starting point 1
(
11.15)
Message:
11.7) or
2072 – GPS signal
11.8)
No reception at starting pt. 2
Possible cause:
– Starting point 2 is in a dead spot
Remedy:
– Change the position of starting point 2
(
11.15)
Message:
2073 – GPS signal
No reception at starting pt. 3
Possible cause:
– Starting point 3 is in a dead spot
Remedy:
– Change the position of starting point 3
(
11.15)
Message:
2074 – GPS signal
No reception at starting pt. 4
11.14)
Possible cause:
– Starting point 4 is in a dead spot
Remedy:
– Change the position of starting point 4
(
11.15)
163