Publicité
Les langues disponibles
Les langues disponibles
13. Docking station
13.1 Docking station controls
A circular red LED (1) provides information
on the status of the docking station and the
wire signal.
Function button (2):
– Switching docking station on and off
– Activating Homecall
– Activating find wire break
LED does not illuminate:
– Docking station and wire signal are
switched off.
LED illuminates continuously:
– Docking station and wire signal are
switched on.
– Robotic mower is not docked.
LED flashes slowly (2 seconds on –
briefly off):
– Robotic mower is docked, battery is
charging if required.
– Docking station and wire signal are
switched on.
144
LED flashes rapidly:
– Perimeter wire is interrupted – wire
break or wire is not correctly connected
to the docking station.(
LED illuminates for 3 seconds, followed
by 1 second pause:
– Homecall was activated.
LED gives 3 short flashes, 3 long
flashes, 3 short flashes, followed by
approx. 5 second pause (SOS signal):
– Error in the docking station.
Switching the docking station on
and off:
The docking station is switched on
and off automatically during automatic
operation.
If the robotic mower is not docked, briefly
pressing the button activates the docking
station. The wire signal remains active for
48 hours if the robotic mower has not
previously docked.
Pressing the button for 2 seconds
switches off the docking station.
Activating Homecall:
Briefly press the button twice within
2 seconds during a mowing
operation.
The robotic mower ends the running
mowing operation, searches for the
perimeter wire and returns to the docking
station to recharge the battery. No further
mowing operation takes place in the
current active time.
Homecall remains active until the
robotic mower is docked. Homecall
can also be ended by pressing the
button on the docking station twice
again.
14. Notes on mowing
16.7)
14.1 General
The robotic mower is designed for the
automatic mowing of lawns. The grass is
kept short through continuous mowing.
The result is a perfect, thick lawn.
Lawns that have not previously been
mown using a conventional lawn mower
will only be mown neatly following several
mowing operations. Especially in the case
of high grass, a good cutting pattern is only
achieved after a few mowing operations.
In hot, dry conditions, the lawn should not
be kept too short as it will otherwise be
burnt by the sun and become unsightly.
The cutting pattern will be better with a
sharp blade than with a blunt one; the
blade should therefore be replaced
regularly.
14.2 Mulching
The robotic mower is a mulching mower.
During mulching, the grass clippings are
further shredded in the mowing deck
housing after cutting. They then fall back
into the turf, where they remain and
decompose.
The finely shredded clippings return
organic nutrients to the lawn, serving as a
natural fertiliser. Fertiliser requirements
are thereby reduced significantly.
0478 131 9936 B - EN
Publicité
