Viking MI 632.1 Manuel D'utilisation page 113

● Installing the docking station
● Routing the perimeter wire
● Connecting the perimeter wire
● Linking the robotic mower and docking
station
● Checking installation
● Programming the robotic mower
● Completing initial installation
The installation assistant must be worked
through in its entirety. Only then is the
robotic mower ready for operation.
An installation video is available
at the www.viking-garden.com
homepage.
Your VIKING specialist dealer can
provide you with further information
on installing the robotic mower.
The installation assistant is re-
activated following a reset (reset to
factory defaults). ( 11.17)
Preparatory measures:
● Mow the lawn using a conventional
lawn mower prior to initial installation
(ideal grass height of 3 to 4 cm).
● In the case of a hard and dry surface,
water the mowing area lightly in order to
make it easier to drive in the fixing pins.
● MI 632 C, MI 632 PC:
The robotic mower must be activated by
a VIKING specialist dealer and
associated with the owner's e-mail
address. ( 10.)
0478 131 9936 B - EN
When navigating through the
menus, follow the instructions in the
section entitled "Operating
instructions". ( 11.1)
You can select options, menu items
and buttons using the control pad.
You can open submenus and
confirm selections using the
OK button.
Use the Back button to
leave the active menu or
jump one step back in the
installation assistant.
If errors or faults occur during the
initial installation, a corresponding
message appears in the display.
( 24.)
9.8 Setting the language, date and time
● Pressing any button on the control
panel activates the machine and thus
the installation assistant.
Select the required display language
and confirm with the OK button.
Confirm your language selection
with the OK button or select
"Change" and repeat the language
selection.
● If necessary, enter the 9-digit serial
number of the robotic mower. This
number is printed on the identification
plate (sticker in compartment under
control panel).
Set the current date using the
control pad and confirm with the OK
button.
111