Publicité
Les langues disponibles
Les langues disponibles
Guide loops with corridors:
To the right and left of the corridor access,
two guide loops (1) have to be installed at
an angle of 90° to the perimeter wire.
These must always be located in the part
of the mowing area that can only be
accessed via a corridor.
Minimum clearance to corridor access:
2 m
If several consecutive corridors are
installed, guide loops must be
installed in each of the relevant
mowing areas.
Installation of a guide loop:
142
Guide loops must not be installed in the
vicinity of corners.
Minimum clearance to corners: 2 m
Install the guide loop in the lawn area as
illustrated. The perimeter wire (1) must be
fastened to the ground with two fixing pins
at the edge A and must not be crossed.
Minimum length: 100 cm
Width: 1 cm
● Attach the guide loop to the ground with
a sufficient number of fixing pins.
12.12 Accurate mowing along edges
At a track offset of 6 cm, a strip with
a width of up to 20 cm is left
unmown along high obstacles. If
necessary, edging stones can be
laid around high obstacles.
Minimum width of edging stones:
Route the perimeter wire with the correct
clearance to the obstacle (e.g. wall)
(27 cm, clearance C on the iRuler). To
ensure that the lawn edge is mown
completely, lay the edging stones along
the wall.
Minimum width: 20 cm
If wider edging stones are laid, the lawn
edge is cut even more precisely.
Route the perimeter wire with
greater clearance to the edging
stones around exterior corners.
(
9.10)
Use wider edging stones if
necessary.
12.13 Sloping terrain in the mowing
area
In order for the robotic mower to
automatically mow a slope in the mowing
area (incline up to 15°) without any trouble,
the perimeter wire must be installed in the
slope with a minimum clearance to the
edge of the incline.
0478 131 9936 B - EN
Publicité
