Scheppach 5904610903 Traduction Des Instructions D'origine page 27

Max. permissible angle of
the motor
Weight
Subject to technical modifications!
Noise and vibration
m Warning: Noise can have serious effects on your
health. If the machine noise exceeds 85 dB (A), please
wear suitable hearing protection.
Noise characteristic values
Sound power level L
WA
Sound pressure level L
pA
Uncertainty K
wa/pA
Vibration characteristics
Vibration a
h
Note: The indicated sound levels have been deter-
mined according to a standardized testing procedure
and can be used to compare different tools with each
other. Furthermore, these values are suitable to eval-
uate the loads that sounds can cause for the user in
advance.
Attention! Depending on how you will use the tool, the
actual values may deviate from the indicated values.
Take measures to protect yourself from noise pollution.
In this process it is important to take the complete se-
quence of operation into account. This also includes
moments during which the power tool operates without
load and moments during which it is turned off. Suita-
ble measures comprise amongst other things regular
maintenance and service of the tool and the insertion
tools, regular breaks and the appropriate planning of
the sequences of operation.
4. Scope of delivery
• 1x Plate Compactor (a)
• 1x Handle (2)
• 2x Star-grip nut with screw (b)
• 1x Rubber pad (c)
• 3x Fastening screw with washer and nut (e)
• 1x Transport fixture (f)
• 1x Spark plug wrench (g)
• 2x Cable tie (h)
• 1x Operator's Manual (i)
25°
aprox. 58 kg
102dB(A) (EN ISO 3744)
79,2dB(A) (EN ISO 11201)
2,72 dB(A)
30 m/s²
www.scheppach.com
5. Unpacking
Open the packaging and remove the device carefully.
Remove the packaging material as well as the packag-
ing and transport bracing (if available).
Check that the delivery is complete.
Check the device and accessory parts for transport
damage. In the event of complaints the carrier must be
informed immediately. Later claims will not be recog-
nised.
If possible, store the packaging until the warranty pe-
riod has expired.
Familiarise yourself with the product by means of the
operating instructions before using for the first time.
With accessories as well as wearing parts and replace-
ment parts use only original parts. Replacement parts
can be obtained from your dealer.
When ordering please provide our article number as
well as type and year of manufacture for your equip-
ment.
m ATTENTION!
The device and packaging materials are not toys!
Children must not be allowed to play with plastic
bags, film and small parts! There is a risk of swal-
lowing and suffocation!
6. Construction
Fitting the handle (fig. A - F):
• Fasten the handle (2) to the plate compactor (a) with
the help of the screw and the star-grip nut (b). Screw
is pushed through from the outside and fastened
with the screw and star-grip nut.
• Now fasten the throttle (1) to the handle (2) (size
8/10). The Bowden cable is fastened to the handle
(2) by mean of cable ties.
Fitting the rubber pad (fig. G + H):
• Rubber pad (c): Place or pull the plate compactor
onto the rubber pad (c) and align the holes. Then
fasten in place from below with the three fastening
screws (e).
Fitting the transport fixture (fig. X + Y):
• Transport fixture (f): Tip the plate compactor for-
wards with the handle (2) and align the transport
fixture (f) in the hole provided for it. The plate com-
pactor can now be set back down again and trans-
ported.
GB | 27