Publicité
Les langues disponibles
Les langues disponibles
PROBLEM
Combustion
blower
does not work.
The convection air fan
runs continuously.
Remote control does
not work (if purchased
/ optional)
In
the
automatic
position
the
stove
always
runs
at
full
power.
The stove does not run
The
stove
does
not
light
ATTENTION
The operations marked in bold type must be carried
out by specialised MCZ personnel.
The manufacturer refuses to accept any responsibility
and the guarantee lapses if this condition is not
respected.
Problems/Causes/Solutions
PELLET STOVES
INSTALLATION AND USE MANUAL
POSSIBLE CAUSES
No electrical supply to the stove.
The motor is broken.
Defective electronic board.
Control panel broken.
Temperature sensor defective or broken.
Fan broken.
Remote control batteries flat.
Remote control broken.
Room thermostat set to maximum.
Temperature sensor defective.
Control panel defective or broken.
Lack of electricity supply.
Pellet sensor in lockout.
Fuse blown.
Make sure that the grate is clean
Check the position of the grate
Make sure that the sparkplug heats
Smoke outlet or duct blocked
REMEDY
Check
the
supply
protection fuse.
Check the motor and capacitor and
replace if necessary.
Replace electronic board.
Replace the control panel.
Check the operation of the sensor
and replace if necessary.
Check the operation of the motor
and replace if necessary.
Replace batteries.
Replace remote control.
Reset the thermostat temperature.
Check the operation of the sensor
and replace if necessary.
Check the panel and replace if
necessary.
Check that the electric socket is plugged
in and that the main switch is in position
"I".
Clear lockout by resetting the rear
thermostat, replace the thermostat if
it happens again.
Replace the fuse.
Clean the grate of any carbon residues or
un-burnt pellets.
Put the grate back in its seat.
Check and replace if necessary.
Clean the smoke outlet and/or vent
system
Technical service - Rights reserved MCZ Group S.p.A. - Reproduction prohibited
Chapter 6
61
page
voltage and the
Publicité
