Publicité
Les langues disponibles
Les langues disponibles
display the word Ma P00 will appear (where the word P00 flashes),
proceed with the programming mode until the day SU=Sunday.
If for a given day of the week you do not want to set any
program, select program 00 and continue with programming.
If a timer program is active but the user decides to
start/stop the stove in advance, the command given
by the user overrides the timer and is carried out.
The next command from the timer is obviously
disregarded.
Example: if the timer calls for the stove to be started
up at 10:00 but the user decides to start it
at 9:00, by pressing button 5 the stove will
come on. At 10:00, the timer, which was
to order start-up, will be disregarded.
IMPORTANT NOTE
It takes 10 to 15 minutes for the stove to start up.
Take this into account when setting the start time.
Likewise, stove shutdown requires about 30 minutes,
during which the heat stored up by the stove is still
released into the room.
Keep this in mind for substantial fuel savings.
TIMER de-activation.
4.10.3.
To de-activate the timer, access the menu again by means of button
OFF.
4.11. PRE-SET WEEKLY AND DAILY PROGRAMS
Weekly programs
4.11.1.
The weekly programs selected by MCZ and stored in the memory of the
control panel were designed to meet the needs of most users who are
out of the home during working hours (factory workers, shopkeepers,
office workers, shift workers) as well as those who are usually at home
(homemakers, senior citizens, etc.).
Also, programming has been provided for those who use the stove in a
weekend home (e.g. a home in the mountains) and want to find the
home warm when they get there.
If you have even more specific needs which are not met by any of
these weekly programs, you can customize weekly program P99 using
seven different programs for each day of the week
4.11.2
).
Operation
PELLET STOVES
INSTALLATION AND USE MANUAL
(see chapter
Technical service - Rights reserved MCZ Group S.p.A. - Reproduction prohibited
Chapter 4
47
page
Publicité
