Publicité
Les langues disponibles
Les langues disponibles
5.1.3. Cleaning the glass
For cleaning the ceramic glass, the use of a dry brush is recommended,
or if it is very dirty, use stove glass cleaner and a soft cloth.
ATTENTION!
Do not clean the ceramic glass until its surface has
been thoroughly cooled.
Do not use abrasive products and do not spray the
cleaning product on the glass of the painted parts or
on the gaskets of the fire door (ceramic fiber cord)
In case of door glass break, it must be replaced with a product of the
same type. Order it referring to code #4 described in chapter 8.2.1. The
glass used in all MCZ stoves is a 5mm ceramic glass type resistant to
1400°F.
To replace the glass remove the door and lay it down in a horizontal
plane. Then unscrew the parts 5a and 5b (refer to figure in chapter
8.2.1). Replace the broken ceramic glass with a new identical one and fix
it again to the door structure, being careful to keep the glass gasket in
the same position as it was before removing the glass.
ATTENTION!
Use only original MCZ ceramic glass for substitution.
The manufacturer refuses to accept any responsibility
and the guarantee lapses if this condition is not
respected.
5.1.4. Cleaning of the air filter
At the back of the stove, at the combustion air intake tube Ø 5 cm,
there is a metallic mesh air filter. Its purpose is to keep dirt out of the
motor body and the internal sensor.
It is advisable to check every 15/20 days whether the filter is clean.
Remove lint or any other material which may have been trapped by the
filter.
Checking and cleaning will be required more frequently if there are pets
in the home.
For cleaning, just turn the knob that holds the filter on the air intake
pipe and remove the filter by turning in the direction indicated by the
arrow. Clean it with a brush, damp cloth or compressed air.
The filter is made of metallic mesh. It is soft and
malleable to the touch. Therefore, when cleaning it,
be careful not to crush it or damage it in any other
way. If it is broken it must be replaced
ATTENTION!
Never operate the stove without the air filter. MCZ
shall not be held liable for damage to internal
components if this instruction is not followed.
Maintenance and cleaning
PELLET STOVES
INSTALLATION AND USE MANUAL
Cleaning the glass
Removing the air filter for cleaning
Technical service - Rights reserved MCZ Group S.p.A. - Reproduction prohibited
Chapter 5
57
page
Publicité
