Publicité
Les langues disponibles
Les langues disponibles
INSTALLATION
3.2.
When installing and operating your MCZ Ego/Star Pellet Stove, respect
basic safety standards. Read these instructions carefully before you
attempt to install or operate the Ego/Star. Failure to do so may result in
damage to property or personal injury and
warranty. Consult with your local building code agency and insurance
representative before you begin your installation to ensure compliance
with local codes, including the need for permits and follow-up
inspections. Several issues must be addressed when selecting a suitable
location for your Ego/Star Pellet Stove. Observing required clearances
to combustible materials, the proximity to a safe chimney or venting
system, and the accessibility of electrical supply must all be considered.
In addition, selecting a location that takes advantage of the building's
natural air flow is also desirable to maximize the heating effectiveness
of the heater. In many cases, this is a central location within the
building. Adequate combustion and ventilation air must be provided.
See Page 11 about venting.
Place the stove on a noncombustible floor surface. If the floor surface is
made of a combustible material, (such as carpet, vinyl or wood), a floor
protector must be installed between the bottom of the unit and the
floor. The floor protector must be non-combustible material extending
beneath the heater and extending to the front, side, and rear as
indicated in the figure below. Place the stove away from combustible
walls at least as far as shown in the pictures on the right side for
different installation conditions. Note that the clearances shown are
minimum for safety but do not leave much room for access when
cleaning or service is needed.
FLOOR PROTECTOR
3.2.1. Alcove installation
As follows the minimum distances for an alcove installation:
Min. Alcove Height: 60"
Min.Alcove Side Wall to appliance: 4"
Max.Alcove Depth: 34"
Installation and fitting
PELLET STOVES
INSTALLATION AND USE MANUAL
may void the product
H = 8" CAN
H = O" USA
F = 18" CAN
F = 6" USA
G = 8" CAN
G = 6" USA
PARALLEL INSTALLATION
BACKWALL VENT EXIT
CORNER INSTALLATION
BACKWALL VENT EXIT
PARALLEL INSTALLATION
CEILING VENT EXIT
CORNER INSTALLATION
CEILING VENT EXIT
Technical service - Rights reserved MCZ Group S.p.A. - Reproduction prohibited
Chapter 3
16
page
Publicité
