Publicité
Les langues disponibles
Les langues disponibles
MOBILE HOME INSTALLATION
3.3.
When installing the Ego/Star in a mobile home several requirements
must be followed:
1. The unit must be bolted to the floor. This can be done with 1/4" lag
screws through the 2 holes in the base plate shown in figure
2. The unit must also be connected to outside air (See page 29).
3. Floor protection and clearances must be followed as shown on page
16.
4. Unit must be grounded to the metal frame of the mobile home.
CAUTION: In mobile home installations the appliance must be
vented to the outside. The user must routinely inspect the
point where air is drawn in to insure that it is clear of
leaves/debris and ice or snow.
Due to high temperatures, the Ego/Star should be placed out of traffic
and away from furniture and draperies. Children and adults should be
alerted to the hazards of high surface temperatures and should stay
away to avoid burn to skin and/or clothing. Young children should be
carefully supervised when they are in the same room as the stove.
Clothing and other flammable materials should not be placed on or near
the Ego/Star Pellet Stove.
Mobile/manufactured
installation in rooms designated for sleeping.
Mobile home installation should be done in accordance with
the manufactured home and Safety Standard (hud), CFr 3280,
Part 24.
THE STOVE IS HOT WHILE IN OPERATION. KEEP
CHILDREN,
CONTACT MAY CAUSE SKIN BURNS.
KEEP COMBUSTIBLE MATERIALS SUCH AS GRASS,
LEAVES, ETC. AT LEAST 3 FEET AWAY FROM THE
POINT DIRECTLY UNDER THE VENT TERMINATION.
THE STRUCTURAL INTEGRITY OF THE MOBILE HOME
FLOOR,
WALL,
EFFECTIVENSS OF ALL VAPOR BARRIERS WITHIN
THE STUCTURE MUST BE MAINTAINED
Installation and fitting
INSTALLATION AND USE MANUAL
home
regulations
CLOTHING
AND
FURNITURE
AND
CEILING/ROOF
PELLET STOVES
do
not
allow
AWAY.
AND
THE
Technical service - Rights reserved MCZ Group S.p.A. - Reproduction prohibited
Chapter 3
17
page
Floor fixing of the appliance
Publicité
