Publicité
Les langues disponibles
Les langues disponibles
INSTALLATION OF AIR FILTER
3.7.
Before placing the stove near the wall for connection to the
flue pipe and to the electrical mains, install the air filter
provided with the stove.
The cylindrical filter is composed of a metallic net and is already
installed on the stove
The filter must be inserted on the air inlet pipe 2".
To remove it, slightly loosen the screw with the knob on the air inlet,
insert the filter matching it with the filter groove with the screw of the
knob and then secure it by tightening the knob.
ATTENTION!
Never operate the stove without the air filter. MCZ
shall not be held liable for damage to internal
components if this instruction is not followed.
3.7.1. Outside Air
Connection to outside air is required for all mobile home installations,
and where building codes require. To install outside air use 2" I.D. flex
pipe. The maximum length run of this pipe is 15 feet. If a longer run is
needed, the size must be increased to 3". The air filter shall be moved
from the air inlet of the stove to the final part of the flex pipe, to keep
dust, birds, rodents, etc. out of the pipe.
MAKING THE ELECTRICAL CONNECTIONS
3.8.
Connect the supply cable first at the rear of the stove and then to an
electrical outlet on the wall.
The main switch located on the rear of the stove should be switched on
only when you want to light the stove.
If you do not intend to use the stove, it is advisable
to keep it switched off.
Installation and fitting
PELLET STOVES
INSTALLATION AND USE MANUAL
Installation/removal of air filter
Electrical connection of the stove
Technical service - Rights reserved MCZ Group S.p.A. - Reproduction prohibited
Chapter 3
29
page
Publicité
