MCZ Star Air Manuel De Fonctionnement Et D'entretien page 40

automatically in order to reach and maintain the set temperature in the
room. This mode is indicated by the word AUTO on the control panel.
With this mode you can also use an advanced function called AUTO-
ECO which is described later (
At each lighting, the stove automatically sets to the
operating mode that it was in the last time it shut
down.
Changing from manual to automatic mode
4.7.1.1.
It is possible to switch from the MANUAL function to the AUTOMATIC
function and vice-versa by selecting the related key on the control
panel.
4.7.2. Manual mode
In this mode you can only vary the heat out-put. This is done selecting
the desired level or power 1-5.
By pressing the switch behind the stove the display of the panel is set
to OFF, by pressing any key the screen with the word MENU will
appear.
With the upper left button select the MANU function (MANUAL
mode). In this mode, using the bottom left button (F) it is possible to
adjust the 5 heating levels. With the bottom right key (C) the speed of
the distribution blower is adjusted.
4.7.3. Automatic mode
Whereas MANUAL mode lets you set a constant out-put level with no
variation over time, AUTOMATIC mode lets you set the desired
temperature to be reached in the room. In this operating mode the
stove will automatically vary the heat out-put to constantly maintain the
temperature in the room at the set value.
From the first screen with the word OFF, press any key and the screen
with the word MENU will appear.
With the upper left button select the AUTO function (AUTOMATIC
mode). In this mode using the bottom left button it is possible to
adjust the temperature desired in the room.
Upon reaching the desired temperature in the room, the stove will
gradually go to minimum power. If the room temperature drops below
the set temperature, the stove will gradually come back up to
maximum hearing performance.
The room temperature is highlighted by the control panel and is
measuring the room temperature from the probe located near the on-
off switch on the bottom rear of the stove.
Operation
PELLET STOVES
INSTALLATION AND USE MANUAL
paragraph 4.7.4.
)
Mode:MANU
Fire:1
70°F
Mode:MANU
Fire:1
Mode:MANU
Fire:1
Manual mode
70°F
Mode:AUTO
Temp:68°F
Mode:AUTO
Temp:68°F
Automatic mode
Technical service - Rights reserved MCZ Group S.p.A. - Reproduction prohibited
Chapter 4
40
page
Menu
Fan:2
21.04
OFF
Menu
Fan:2
Menu
Fan:2
21.04
OFF
Menu
Fan:2
Menu
Fan:2