MCZ Star Air Manuel De Fonctionnement Et D'entretien page 25

PREPARATION AND UNPACKING
3.5.
STAR AND EGO stoves are packed differently:
The EGO stove has one crate

It contains the stove and the steel sides with the
o
profiles (Fig.1)
The STAR stove has two parts

One contains the stove and the profile for the ceramic
o
or the soapstone
One contains the ceramic (fig.2). In this case there will
o
be a single package for the structure (the cardboard
with the ceramics will be placed on top of the stove
crate)
or Soapstone (fig.3) (in this case there are two
o
packages - structure + soapstone pallet)
Open the packaging, remove the four screws that secure the base of
the stove to the pallet, two to the right and two to the left (see figure
4), and position the stove in the selected place, ensuring that it is
complies with the above instructions.
Figure 4 - Removing packaging screws (in
figure Ego stove)
The stove body or unit must always be kept in a vertical position when
moved and should be moved with a dolly or hand truck. Special care
must be used to protect the door and the glass from impacts that
would damage them.
Moving the product must always be done with care. If possible, unpack
the stove in the area where it is going to be installed.
Installation and fitting
PELLET STOVES
INSTALLATION AND USE MANUAL
Figure 1 – Example of packaging stove
+ steel sides (Ego stove)
Figure 2 - Example of packing for
ceramics
Figure 3 - Example of soapstone
packaging
Technical service - Rights reserved MCZ Group S.p.A. - Reproduction prohibited
Chapter 3
25
page