MCZ Star Air Manuel De Fonctionnement Et D'entretien page 35

4.4.3. General characteristics of the LCD remote control
The EGO and STAR stoves are mainly controlled by the control panel
that is found above the stove. As an accessory, it is in any case
possible to purchase the remote control that manages the main
functions: on/off, power adjustment, hot air fan speed adjustment,
automatic function.
Keep the remote control away from direct heat and
water.
It is advisable to keep it out of the reach of children.
4.4.4. Type of batteries and replacement
To substitute the battery, it is necessary to extract the battery-holder
(as shown on the figure on the back of the remote control), and
remove or insert the batteries following the symbols printed on the
remote control and the battery itself.
Operation requires 1 CR 2025 Lithium battery.
Used batteries contain metals which are harmful for the
environment; they must therefore be disposed of
separately in the special containers.
If the remote control is off due to the absence of
batteries, it is possible to control the stove from the
control panel, located in the upper part of the stove.
The batteries provided have a limited lifespan to
allow first lighting of the stove and for the user to
learn how to use the device.
When replacing the batteries, ensure correct polarity
by observing
compartment of the remote control.
SETTINGS TO CARRY OUT BEFORE FIRST
4.5.
LIGHTING
Once the power cord is connected to the rear part of the stove, place
the switch, also on the rear, to position (I).
The lighted button of the switch will come on.
The stove is off and the screen on the control panel will appear with
the word OFF; by pressing any key the screen the word MENU will
appear.
Operation
PELLET STOVES
INSTALLATION AND USE MANUAL
the symbols on the internal
Technical service - Rights reserved MCZ Group S.p.A. - Reproduction prohibited
Chapter 4
35
page