Fault; Troubleshooting; Table Of Alarm Indications - Angelo Po AT 61E Manuel D'utilisation

Masquer les pouces Voir aussi pour AT 61E:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

TROUBLESHOOTING

The appliance has been tested before being put into service.
The information provided below is intended to assist in the identifi cation and correction of any
anomalies and malfunctions which might occur during use.
The user can solve some of these problems himself, but for others specifi c technical knowledge
or skill is required, and so they must only be carried out by qualifi ed staff with recognised
experience acquired in the specifi c sector of operation.
Important
For all requirements contact the agents or the headquarters of Angelo Po which can be found
in the contacts section of the website http://www.angelopo.com.

Fault

The appliance does not switch on
Cooking cycle does not start or
stops suddenly
The cleaning cycle does not
start or stops suddenly
GB

TABLE OF ALARM INDICATIONS

If the problem or fault noticed is not amongst those
listed in the table, consult the "Key to Alarms" table
provided below.
The information provided below s intended to identify
the alarm signals which appear on the display (A).
Important
Press RESET to reset the alarm and the cooking cy-
cle restarts automatically. Press START if the cook-
ing cycle does not restart automatically.
3378702_ATE_ut_GB
FAULT
Cause
Fuse "blown"
Safety or protection device (safety
thermostat or overload cutout)
tripped.
Electronic circuit board damaged
Control board electronic circuit
board damaged
Alarm triggered
Control board electronic circuit
board damaged
Alarm triggered.
- 36 -
Remedy
Replace the fuse (see "installation
manual).
Press device reset button.
Contact the after-sales service.
Contact the after-sales service.
Consult the "Key to Alarms" table
Contact the after-sales service.
Consult the "Key to Alarms" table
A
ENGLISH

Publicité

Table des Matières

Dépannage

loading

Table des Matières