Securing The Bottle Opener; Placing The Grease Bucket; Connecting To A Power Source - Pit Boss PB700R2 Assemblage Et Fonctionnement

10. SECURING THE BOTTLE OPENER

Parts Required:
1 x Bottle Opener (#12)
Installation:
• Secure the bottle opener onto the right-front leg using the pre-
installed screws on the leg.

11. PLACING THE GREASE BUCKET

Parts Required:
1 x Grease Bucket (#13)
Installation:
• Place the grease bucket on the spout hook on the end of the main
barrel. Ensure it is level to avoid grease spills.
• The unit is now completely assembled.

12. CONNECTING TO A POWER SOURCE

NOTE: Before plugging your Pit Boss® into any electrical outlet,
ensure the temperature dial is in the OFF position.
• STANDARD OUTLET
This appliance requires 110-120 volt, 60Hz, 275W. It must be a 3-prong
grounded plug. Ensure grounded end is not broken off before use. The
control uses a 110-120 volt, fast-blow fuse to protect the board from
the igniter.
• GFCI OUTLETS
This appliance will work on most GFCI outlets, with a recommended
size of 15 amp service. If your GFCI outlet is highly sensitive to power
surges, it will likely trip during the start-up phase of operation. During
the start-up phase, the igniter draws 200-700 watts of electricity
which can be too much power for a GFCI outlet to handle. Each time it
trips, it increases in sensitivity. If the GFCI keeps tripping, replace the
outlet or change to a non-GFCI outlet.
ON THE ROAD
•
Disconnect the igniter from the main wiring harness. Use the manual
start-up procedure. A Pit Boss® unit can operate using a 12 volt,
100 watt inverter plugged into your automobile outlet. To use the
automatic igniter, it is recommended to use a minimum of a 1000 watt
inverter.
IMPORTANT: Disconnect unit from power source when not in use.
10
12
11
13
12
FAST-BLOW FUSE
11