Regulator-Valve Housing Assembly; Igniter Housing Assembly - Pit Boss TG2SS Instructions Et Utilisation

2

REGULATOR-VALVE HOUSING ASSEMBLY

Insert the end of the regulator valve nozzle into the open end of the burner tube
(venturi). Align the holes in the Regulator Housing with the threaded holes in the
grill firebowl and insert two 5/32 x .31" bolts through the holes in the housing into
the threaded holes in the firebox. Tighten the bolts securely.
3

IGNITER HOUSING ASSEMBLY

• A - Thread the Electrode Wire through the hole in the Igniter Housing and
attach the end onto the pin at the bottom end of the Piezo Igniter.
• B - Align the holes in the Igniter Housing with the threaded holes in the firebowl
end. Insert Four 5/32 x .31" bolts through the housing into the threaded holes.
When installing the fourth bolt, first insert it through the ring at the end of the
Match holder chain and then through the Housing and into the firebowl end.
Tighten the bolts securely.
All manuals and user guides at all-guides.com
6