Scan Mode Period" Function; Mute" Function; Load Default" Function; Brightness" Function - Sygonix 1594378 Mode D'emploi

j) "Scan Mode Period" function
You can use the " " symbol in the OSD menu (see section 10. c), position "C" or the "
remote control to enable/disable scan mode. This function allows you to configure how long each camera image is
displayed for.
When you access this function, a list of the possible time intervals is displayed (5, 10, 15, 20, 30 seconds).
Use the touchscreen (or the arrow buttons ("
the desired duration.
Touch the "
go back to the previous display without applying any changes.
k) "Mute" function
This function mutes the monitor/DVR speaker. Audio signals transmitted from the camera to the monitor/DVR will be
recorded as usual, but will not be played through the speaker.
Use the touchscreen (or the arrow buttons ("
able/disable the mute function.
Touch the "
go back to the previous display without applying any changes.
l) "Load Default" function
This function restores all monitor/DVR settings to the factory defaults.
Use the touchscreen (or the arrow buttons ("
confirm whether you wish to restore factory settings.
Press the "
previous display.
m) "Brightness" function
The brightness of the LCD backlight can be adjusted to suit the surroundings.
Use the touchscreen (or the "
ness level.
To save the settings, touch the "
control.
Press the "
display.
" and "
" symbol on the touchscreen, or press the "
" and "
" symbol on the touchscreen, or press the "
" and "
" button (31) on the IR remote control to cancel the setting/selection and go back to the
", " ", " " and "
" symbol on the touchscreen, or press the "
" button (31) on the IR remote control to cancel the setting and go back to the previous
") and the " " button (28) on the IR remote control) to select
" button (31) on the IR remote control to
") and the " " button (28) on the IR remote control) to en-
" button (31) on the IR remote control to
") and the " " button (28) on the IR remote control) to
" buttons on the IR remote control) to select the desired bright-
" button (30) on the IR
" button (28) on the IR remote
75