Residual Risks - SKF TLMP 1008 Serie Mode D'emploi

1. Safety instructions

1.19 Residual risks

Residual risk
Personal injury/ material damage due to
falling of raised parts
Personal injury/ material damage due to
tilting or falling of the product because of
non-observance of the stated tightening
torques
Personal injury/ material damage due to
electric shock in case of damage to the
connection cable
Personal injury/ damage to material due
to spilled or leaked lubricant
Life cycles:
A = transport, B = installation, C = initial start-up, D = operation, E = cleaning, F = maintenance, G = fault, repair, H = shutdown, K = disposal
Possible in life cycle Prevention/ remedy
Keep unauthorized persons away. No people may remain under suspended
A B C G H K
loads. Lift parts with adequate lifting devices.
Observe the specified tightening torques. Fix the product only to components
with sufficient load capacity.
B C G
If no tightening torques are stated, apply tightening torques according to the
screw size characteristics for 8.8 screws.
Check the connection cable with regard to damages before the first usage and
B C D E F G H then at regular intervals. Do not mount cable to moving parts or friction points. If
this cannot be avoided, use spring coils respectively protective conduits.
Be careful when filling the reservoir and when connecting or disconnecting lubri-
cant feed lines. Always use suitable hydraulic screw connections and lubrication
B C D F G H K lines for the stated pressures. Do not mount lubrication lines to moving parts or
friction points. If this cannot be avoided, use spring coils respectively protective
conduits.
EN EN
1
15