SKF TLMP 1008 Serie Mode D'emploi page 294

1. Safety instructions
1.16 Transport, installation, maintenance,
malfunctions, repair, shutdown,
disposal.
○ All relevant persons must be informed
of the activity prior to starting any work.
Observe the precautionary operational
measures and work instructions.
○ Carry out transport using suitable trans-
port and hoisting equipment on suitable
ways only.
○ Maintenance and repair work can be sub-
ject to restrictions in low or high tempe-
ratures (e.g. changed flow properties of
the lubricant). Therefore, where possible,
try to carry out maintenance and repair
work at room temperature.
○ Prior to performing work, the product
and the machine, into which the product
will be integrated, must be depressuri-
zed and secured against unauthorized
activation.
○ Ensure through suitable measures that
movable or detached parts are immobi-
lized during the work and that no limbs
can be caught in between by inadvertent
movements.
○ Assemble the product only outside of the
operating range of moving parts, at an
adequate distance from sources of heat
or cold. Other units of the machine or ve-
hicle must not be damaged or impaired in
their function by the installation.
○ Dry or cover wet, slippery surfaces
accordingly.
○ Cover hot or cold surfaces accordingly.
○ Work on electrical components must
be carried out by electrical specialists
only. Observe any waiting periods for
discharging, if necessary. Carry out works
on electrical components only while the
system is depressurized and use voltage
isolated tools suitable for electrical works
only.
○ Carry out electrical connections only ac-
cording to the information in the valid
wiring diagram and taking the relevant
regulations and the local connection con-
ditions into account.
○ Do not touch cables or electrical compo-
nents with wet or damp hands.
○ Fuses must not be bypassed. Replace
defective fuses always by fuses of the
same type.
○ Ensure proper grounding of the product.
○ Ensure proper connection of the protec-
tive conductor.
○ Undertake drilling at non-critical, non-
load bearing parts only. Use any available
boreholes. Do not damage lines and ca-
bles when drilling.
○ Observe possible abrasion points. Protect
the parts accordingly.
EN EN
1
13