SKF TLMP 1008 Serie Mode D'emploi page 324

10. Troubleshooting
10. Troubleshooting
Fault messages
Fault message on the display
Fault signal LI
Fault signal LL
Fault signal EP
Fault signal Er
If the fault cannot be determined and remedied, please contact our Customer Service.
Meaning
○ Pre-warning empty
There is little lubricant available. The display
alternates with "pump is on".
○ Low-level indication
No lubricant available anymore. The pump still
completes the current lubrication cycle. A restart
can take place only after refilling the reservoir.
○ Fault of the membrane keypad or
○ fault of the display
○ An unspecified error is pending.
Remedy
○ Fill reservoir
○ Fill reservoir
○ Replace membrane keypad
○ Replace control printed circuit board
○ Replace the control printed circuit board. If ne-
cessary, replace the entire pump.
EN
10
43