Delivery, Returns, And Storage - SKF TLMP 1008 Serie Mode D'emploi

5. Delivery, returns, and storage

5. Delivery, returns, and storage
5.1 Delivery
After receipt of the shipment, check the
shipment for damage and completeness
according to the shipping documents. Im-
mediately report any transport damages to
the forwarding agent.
Keep the packaging material until any dis-
crepancies are resolved. During in-house
transport ensure safe handling.
5.2 Returns
Clean all parts and pack them properly (i.e.
following the regulations of the recipient
country) before returning them.
Protect the product against mechanical
influences such as impacts. There are no re-
strictions for land, sea or air transport.
Mark returns on the packaging as follows.
5.3 Storage
Before application inspect the
products with regard to possible
damages occurred during their
storage. This particularly applies
for parts made out of plastic and
rubber (embrittlement) as well
as for components primed with
lubricant (ageing).
SKF products are subject to the following
storage conditions:
○ the admissible storage temperature
range corresponds to that of the opera-
ting temperature (see Technical data)
○ dry, dust- and vibration-free in closed
premises
○ no corrosive, aggressive materials at the
place of storage (e. g. UV rays, ozone)
○ protected against pests and animals
○ in the original product packaging
○ shielded from nearby sources of heat and
coldness
○ in case of high temperature fluctuations
or high humidity take adequate measures
(e. g. heater) to prevent the formation of
condensation water.
EN
5
33