SKF TLMP 1008 Serie Mode D'emploi page 306

3. Overview, functional description
3.4 Displays in the display mode
Ready for operation
The pump is in the pause mode. There are no
fault indications pending.
On
min h
Pump is on
The pump is in the operating mode. There are
no fault indications pending.
On
min h
Pre-low-level signal
The pump is in the operating mode. There is
little lubricant available. The display alternates
On
with "pump is on".
min h
Low level indication
Lubricant lacks. The pump terminates the cur-
rent lubrication cycle. It can be restarted only
On
after refilling the reservoir.
min h
Fault signal Er
An unspecified error is pending.
On
min h
Fault signal EP
A fault of the membrane keypad or the display
is pending.
On
min h
3.5 Displays in the programming mode
Programming step P1
In this step the hourly data of the pause time is
set..
On
min h
Programming step P2
In this step the minute value of the pause time
is set.
On
min h
Programming step P3
In this step the number of metering device cycles
per operating cycle is set.
On
min h
Programming step P4
In this step the type of output signal is set.
nc = normally closed contact
On
no = normally open contact
min h
Programming step P5
In this step it is determined whether a differen-
tiation is made between a fault signal or a low-
On
level signal.
min h
Programming step P6
In this step it is set how the pump will start when
being switched on.
On
SP = Start with pause time
SO = Start with lubrication time
min h
EN
3
25