Electrical Connection - SKF TLMP 1008 Serie Mode D'emploi

6. Assembly

6.5 Electrical connection

Electrical connections must be done in such
way that no forces are transferred to the
product (tension-free connection). For elec-
trical connection proceed as follows:
Square plug
• Use adequate cable to configure square
plug without cable. For connection of the
cable, see wiring diagram on square plug
or corresponding wiring diagram in these
Instructions (see chapter 12).
• Remove protective caps from the electri-
cal connections of the pump.
• Place plugs with sealing onto connections
and fasten them by means of a screw.
NOTE
Observe the electrical characteristics (see
chapter 4).
EN
6
37