Table des Matières
Publicité
Use these procedures only if a complete network reset is required.
Contact Customer Service to understand if you need to perform these steps.
Network Reset
Local Reset - Motor
Local Reset - Remotes
Hold
Hold
Hold
Hold
1. Press and hold the button on the headrail
endcap until the shade jogs once (about 7
seconds), then release the button. The LED
will go from solid green, flashing green, and go
to flashing amber.
NOTE: Shade limits are not lost. All controllers will
be removed from the motor's memory.
1. Press and hold the button on the headrail
endcap until the shade jogs twice (about 15
seconds), then release the button. The LED will
go from solid green, flashing green, to flashing
amber then go to rapid flashing red.
NOTE: Factory limits are set in the motor at about
2" to 4" apart. All controllers will be
removed from the motor's memory.
1. Press and hold the programming button until
the LEDs stop flashing. LEDs will flash green,
amber, red, and then finally turn off (about
15 seconds).
NOTE: Local reset must be performed on both the
controllers and motors. All motors will be
removed from the remotes memory
15
Publicité
Table des Matières
