Reversing Motor Direction - Springs Window Fashions Cord Loop Guide D'installation

Reversing Motor Direction

Each shade is pre-programmed from the factory to operate up and down corresponding to the appropriate buttons on
your remote(s). However, if the directions are inadvertely reversed, follow these steps to return the shade to
proper operation.
A time-out can occur during programming the remote or motor, when no buttons are pressed within
a predetermined amount of time. This remote or motor will revert back to a user state. Simply repeat
programming steps if the remote or motor has timed-out.
Fig. 1
Hold
Hold
Fig. 2
Hold
Hold
Fig. 3
1. Move the shade to a position between the
upper and lower limits. Press and release a
directional button to set the shade in motion.
Press the opposite directional button to stop
the shade. (Fig. 1)
2. Press and hold UP and DOWN buttons
until the LED light turns amber (about 3
seconds) then release buttons. (Fig. 2)
The shade will jog and the LEDs on the motor
will begin to flash green and red and the LEDs
on the remote will flash green.
3. Press and hold the UP and DOWN buttons
until the LED turns amber (about 3 seconds)
then release buttons. (Fig. 3)
Shade direction has now been reversed;
however, the upper and lower limits have
been maintained.
9