Springs Window Fashions Cord Loop Guide D'installation page 51

Adding Secondary Remotes to a Group of Shades for Individual Control Using a Two-Button
Remote as Primary.
Adding individual control to shades that are part of a newly formed group. This remote will now be referred to as the
secondary control.
2x
Fig. 1
Hold
Fig. 2
1x
Fig. 3
Fig. 4
14
Hold
1. Joining a secondary remote to the primary remote.
A. Starting with the primary control, press and
release the program button on the back side
of the current remote twice in rapid
succession (2 taps). The LED light will flash
alternating amber and green to identify
inclusion mode. (Fig. 1)
B. Press and hold the program button on the
secondary remote control until the LED light
flash green (about 3 seconds), then release
the button. (Fig. 2.) Both the primary and
secondary remote LEDs will flash green, then
turn off confirming inclusion.
2. Associate secondary control to the motor.
A. Press and release the program button on the
back side of the secondary control once. The
LED will flash green. (Fig. 3)
B. Press and hold the program button on the
target shade headrail or motor end until the
LED light flashes green (about 3 seconds),
then release button. (Fig 4.) The LED on the
secondary control will turn green and the
shade will jog. Both the primary (group) and
secondary (individual) controls will now
operate the shade.
Repeat this process on all shades you want to
individually control.