Adding Remotes And Creating Groups; Adding A New Remote When The Only Remote Controlling The Shade Is Lost - Springs Window Fashions Cord Loop Guide D'installation

Adding Remotes and Creating Groups

Your motorized shades are pre-programmed from the factory with the appropriate pairing and grouping between remotes
and shade motors. There are several scenarios when additional programming steps will be required. The next sections
explain how to accomplish the most common scenarios you will encounter. If the appropriate scenario is not included,
please contact a customer service representative prior to attempting any adjustments.

Adding a New Remote When the Only Remote Controlling the Shade is Lost

If you no longer have your remote, or the remote has been damaged and no longer works, follow these steps.
Fig. 1
Fig. 2
Fig. 3
A time-out can occur during programming the remote or motor, when no buttons are pressed within
a predetermined amount of time. This remote or motor will revert back to a user state. Simply repeat
programming steps if the remote or motor has timed-out.
10
Hold
2x
Hold
1. Press and hold the program button on the
headrail/motor end, the LED will flash green
then amber (about 7 seconds). When the
shade jogs once, release the button and the
LED will turn solid amber and turn off. The
Hold
motor is now ready to be associated to a new
remote. (Fig. 1)
2. Using a paper clip or a similar item, press and
release the programming button located on
the back side of the new remote twice in rapid
succession (2 taps) The LED on the remote will
flash alternatively amber and green. (Fig. 2)
3. Press and hold the program button on the
headrail/motor end, release when LED flashes
green (about 3 seconds). (Fig. 3.) The shade
will jog and all LED's will turn off.The shade
will now operate from the newly added remote.
Hold