Table des Matières
Publicité
Adjusting Your Shade's Home Position (optional)
If your shade system includes an optional single-channel remote, it has been pre-programmed to control your shade(s).
The default
position (intermediate position) is pre-set to mid-length of your shade. To change the
these steps.
Note: if the single-channel remote controls multiple shades as a group, refer to the next section.
Note: Always adjust the upper and lower limits before adjusting your
limits, the
position will reset to the new mid-length position.
A time-out can occur during programming the remote or motor, when no buttons are pressed within
a predetermined amount of time. This remote or motor will revert back to a user state. Simply repeat
programming steps if the remote or motor has timed-out.
1. Use the UP or DOWN button to put the shade in
motion. When the shade reaches your desired
position, press and release
2. To set your
position, press and hold the
button until the LED on the remote turns amber (about
3 seconds), then release the button. The shade will jog
and the new
position is set.
Hold
position. After adjusting the upper or lower
position, follow
to stop the shade.
7
Publicité
Table des Matières
