Adjusting The Home Position On A Group Of Shades (Optional) - Springs Window Fashions Cord Loop Guide D'installation

Adjusting the Home Position on a Group of Shades (optional)

If your shade system includes an optional single-channel remote as a group control, it has been pre-programmed to
control your shades. The default
position on multiple shades, follow these steps.
Fig. 1
Fig. 3
Fig. 4
Notes:
• Always adjust the upper and lower limits before adjusting your
limits, the position will reset to the new mid-length position.
• You are required to access the motor head to adjust the
A time-out can occur during programming the remote or motor, when no buttons are pressed within
a predetermined amount of time. This remote or motor will revert back to a user state. Simply repeat
programming steps if the remote or motor has timed-out.
8
position (intermediate position) of all shades is pre-set to mid-length. To change the
1x
Fig. 2
Hold
Hold
Fig. 5
1. Press and release the
group of shades to their pre-programmed
position. (Fig. 1)
2. In order to adjust the
shade, you must first target the individual
shade you want to adjust. To do this, press
and release the program button on the back
of the single-channel remote (one tap). The
LED on the remote will alternately flash green.
(Fig 2)
3. Then on the shade that you want to adjust,
press and hold the program button on the
headrail/motor end until the LED begins to
flash green (about 3 seconds) and release.
The shade will jog. (Fig. 3)
4. Using the two-button remote that controls the
shade, adjust the shade to the new desired
position. (Fig. 4)
5. Using the single-channel remote, press and
HOLD the button until the LED turns
amber (about 3 seconds) and release the
button. The shade will jog and the
of the target shade is now reset. (Fig. 5)
6. Repeat process for additional shades to
adjust the new desired
position. After adjusting the upper or lower
position.
button to bring the
position of each
position
position.