Reasigning A Two-Button Remote As A Group Control - Springs Window Fashions Cord Loop Guide D'installation

Reassigning a Two-Button Remote as a Group Control
This process is followed when the end user desires to reassign a two-button remote to control a group of shades. You
must first exclude all individual two-button remotes and include the two-button remote you desire as the primary controller.
NOTE: This two-button remote will no longer perform as a individual motor controller.
3x
Fig. 1
Fig. 2
2x
Fig. 3
Fig. 4
Hold
Hold
1. Exclude the two-button remote as the primary
control.
A. Press and release the program button on the
back of the remote three times in rapid
succession (3 taps). The LED will flash,
alternating amber to identify exclusion
mode. (Fig. 1)
B. Press and hold the button on the headrail/
motor end until the LED begins to flash green
(about three seconds), and release. The LED
on the motor will turn solid green, then turn off
and the shade will jog, confirming exclusion.
(Fig. 2)
Repeat this process for each motor to be added to
this group.
Go to page 14 to add secondary remotes to shades
in the group for individual control.
2. Include two-button remote as the primary
controller of a group of shades.
A. Press and release the program button on the
back of the remote twice in rapid succession
(2 taps). (Fig. 3.) The LED on the new group
remote will flash alternately amber and green
to identify inclusion mode.
B. Press and hold the program button on the
headrail/motor end until the LED flashes
green (about 3 seconds), and release. (Fig. 4.)
The shade will jog and all LED's will turn off.
The shade will now operate from the newly
added remote.
Repeat this process for each motor to be added to
this group.
Go to page 14 to add secondary remotes to shades
in the group for individual control.
13