Table des Matières
Publicité
Adding a New Single-Channel Remote as a Group Control
If a group control was not selected at the time of purchase and is being added to an existing motorized shade, follow the
steps below.
Note: Individual shade control will be restored with the original two-button remote only after it has been reassociated
with the shade as a secondary remote. (see next page).
3x
Fig. 1
Fig. 2
2x
Fig. 3
Fig. 4
A time-out can occur during programming the remote or motor, when no buttons are pressed within
a predetermined amount of time. This remote or motor will revert back to a user state. Simply repeat
programming steps if the remote or motor has timed-out.
Hold
Hold
1. Exclude the two-button remote as the
primary control
A. Press and release the program button on the
back of the remote three times in rapid
succession (3 taps). The LED will flash,
alternating amber to identify exclusion
mode. (Fig. 1)
B. Press and hold the button on the headrail/
motor end until the LED begins to flash green
(about three seconds), and release. The LED
on the motor will turn solid green, then turn off
and the shade will jog, confirming exclusion.
(Fig. 2)
2. Include the new group remote as the
primary control.
A. Press and release the program button on the
back of the remote twice in rapid succession
(2 taps). (Fig. 3.) The LED on the new group
remote will flash alternating amber and green
to identify inclusion mode.
B. Press and hold the program button on the
headrail/motor end until the LED flashes green
(about 3 seconds), and release. (Fig. 4.) The
shade will jog and all LED's will turn off.The
shade will now operate from the newly added
remote.
Repeat this process for each motor to be added to
this group.
Go to page 12 to add secondary remotes to shades
in the group for individual control.
11
Publicité
Table des Matières
