Table des Matières
Publicité
Basic Shade Control
Upon first power up, you will see a green light illuminate on the headrail or motor end of the shade. This will happen
whenever power is first applied or restored after an outage. Press the UP or DOWN button to operate the shade.
Note: you can press and release the opposite directional button to stop the shade while it is in motion.
Press and
release the
UP button
to fully open
the motorized
shade.
Momentary Movement: Press and hold the directional buttons (UP or DOWN) to operate shade. Releasing the
directional button will stop the movement.
Control Features
Operating your shade with the two-button remote or optional single-channel remote.
Your controls have been pre-programmed to control your shade. The upper and lower limits and
position have already been set. If you are not satisfied with the default upper, lower, or
of your shade, see steps in the following sections of this manual.
Home Button − Single-Channel Remote
UP Button
DOWN Button
HOME Button
(Intermediate/favorite)
button: Acts as a STOP button while shade is in
motion. It can also be programmed as a quick way to
bring shades to your preferred intermediate position.
Press and release
your shade to your
Press and release
stop the shade.
Press and
release the
DOWN button
to fully close
the motorized
shade.
while your shade is at rest will bring
position.
while the shade is in motion will
position
3
Publicité
Table des Matières
