Creo Medical 7-EMR-050 Instructions D'utilisation page 23

Additional Settings
Change Speaker Volume and Screen Brightness
Caution
Ensure the tones are audible over the typical background noises.
To enable the adjustment of the Speaker Volume and Display Screen Brightness, press and
hold the Front Panel Menu button
acknowledgement, then release the Menu
Additional Settings:
Speaker Volume: Speaker Volume:
Display Brightness:
Software Version:
ID:
The Additional Settings screen is displayed. While this screen is displayed, the speed of the
cooling fans in the Electrosurgical Generator is increased, providing some additional
background noise to assist in judging the preferred speaker volume.
To adjust either the Speaker Volume or Screen Brightness, briefly press the Menu button
highlight the setting to be adjusted. Pressing the Menu button
choices. Once the setting is highlighted, use the + and – Control Buttons (4) to adjust the
setting.
When the adjustments are made, confirm each setting by briefly pressing the Menu button
Once the desired settings are set, press the Menu button
Generator sounds an audible acknowledgement. On release of the Menu button
Electrosurgical Generator Display will revert to the Treatment Screen.
Please note - Other information is also displayed on this screen and is intended for product
servicing use only; these values are not adjustable by the user.
(5) until the Electrosurgical Generator sounds an audible
button.
1 1
1
VX.YZ
XXXXXXXX
toggles between these two
until the Electrosurgical
Page 23 of 248
to
.
the