Driving Shaft Check - MOTO GUZZI V750 IE Mode D'emploi

ENGINE
4.12.2.

DRIVING SHAFT CHECK

•
Apply thread locking paste to plug thread and screw it
firmly back into place.
•
Clean lubricant passages with compressed air.
NOTE Driving shaft is nitrided therefore cannot be ground; if
wear, ovalization or deep scratching has occurred driving
shaft must be replaced.
Diameter of timing side crankshaft journal
Normal (production) mm (in)
40,023 ÷ 43,007
(1.5757 ÷ 1.6932)
Diameter of flywheel side main bearing seat
Normal (production) mm (in)
47,130÷47,142
(1.8555 ÷ 1.8560)
Total thickness for flywheel side main bearing
Normal (production) mm (in)
2,044÷2,050
(0.0805 ÷ 0.0807)
Clearance between crankshaft and flywheel side m
bearing
Normal (production) mm (in)
0,007÷0,047
(0.0003 ÷ 0.0018)
4 - 88
ain
V750 IE