MOTO GUZZI V750 IE Mode D'emploi page 774

Engine 750 Euro 4
•
Remove the gasket from the stud bolts
Disassembling the piston
•
Remove one of the two retainer rings
from the pin paying attention that it
does not fall inside the engine
•
Before removing the pin, check the
mounting clearance between pin and
piston. Replace it if the value is out of
the limits
•
Slide off the pin
Characteristic
Mounting clearance between piston and pin
0.015 mm (0.00059 in)
•
Remove the piston
CAUTION
DURING SERVICING, CLEAN OFF ANY DEPOSITS FROM
PISTON CROWN AND CIRCLIP GROOVES
Engine
ENG - 79