MOTO GUZZI V750 IE Mode D'emploi page 722

Engine 750 Euro 4
•
Remove the gearbox cover with a few
mallet strokes
•
To remove the bearings fitted in the
gearbox crankcases, the safety wash-
er must be removed first
CAUTION
PAY ATTENTION WHEN REMOVING THE BEARING SAFE-
TY WASHERS, THEY HAVE TWO DIFFERENT SIZES.
THE SMALL WASHERS MAY BE PLACED ERRONEOUSLY
INSTEAD OF THE ONES WITH LARGER SIZE
•
The bearings from the gearbox crank-
cases can be removed using generic
extractors.
•
Remove the drive shaft secondary oil
gaiter
CAUTION
IN CASE OF OIL SEAL REPLACEMENT, USE THE SUITA-
BLE PUNCH UNTIL IT REACHES THE CRANKCASE
Specific tooling
020978Y Cardan secondary oil seal mounting
punch
Removing the primary shaft
CAUTION
FIT NEW CIRCLIPS WHEN REASSEMBLING
Engine
ENG - 27