Adjusting The Rear-View Mirrors; Starting The Engine - SWM RS 300 R 2019 Manuel - Utilisation - Entretien

- Start the motorcycle as described in the relevant
section.
Dismounting the motorcycle
- Stop the vehicle and switch off the engine.
CAUTION*: Make sure that the area where you
want to park the vehicle is stable and level.
- Place both feet on the ground.
- Switch off the motorcycle as described in the rel-
evant section.
- Using your left leg, fully extend the stand.
- Firmly grasp the handlebar and dismount on the
left-hand side by lifting your right leg.
- Holding the motorcycle by the handlebar, use one
foot to lower the lateral stand and hold it down
while the motorcycle is rested on it.

ADJUSTING THE REAR-VIEW MIRRORS

Sit on the motorcycle as described in the relative
paragraph.
Adjust both mirrors (1) so that you can clearly see
the road behind you when seated.
1

STARTING THE ENGINE

With cold engine, i.e., after the motorcycle has not
been used for a while or in low ambient tempera-
tures, operate in the following manner:
1) Place ignition key (1) to ON position (the buzz that
you hear when you turn the key to ON is caused
by the fuel pump which puts the feeding system
under pressure);
2) pull the starter knob (2);
3) pull the clutch lever (3);
4) shift the gear pedal (4) into neutral position;
5) Check that the button (5) is in the out position
and press it, followed by the start button (6).
Put the knob (2) in its initial position as soon as
the engine is idling
When starting with an already warmed up en-
gine DO NOT USE the starter. When a cold engine
has just been started, do not increase revs, to
ensure an adequate oil warm-up and circulation.
Note*: A safety switch is fitted on the clutch lever
support that allows starting ONLY when the clutch
lever is pulled.
EN - 19