SWM RS 300 R 2019 Manuel - Utilisation - Entretien page 124

- Pump with brake lever (3) or brake pedal (3A) in
order to push brake fluid out of line.
- Close the bleeding valve and fill the reservoir
with fresh brake fluid.
- Open the bleeding valve, apply the brake us-
ing the brake lever or pedal, close the bleeding
valve with the brake lever or pedal applied and
then quickly release the lever or pedal.
- Repeat this operation until the brake line is filled
and clear fluid starts coming out of the plastic
hose: now close the bleeding valve.
- Restore the brake fluid level (A) or (B) then reas-
semble the rubber and the fluid reservoir cap.
After changing the fluid, bleed the system as described
in the relative paragraph.
EN - 52
3
A
3A
B