Set Up - Led Light (If Available); Set Up - Laser Indicator (If Available) - Corghi CompactLine EM 9250 Manuel D'utilisation

- 8- maximum display brightness value
- press the button

15.12. SET UP - LED LIGHT (IF AVAILABLE)

The machine allows the operator to disable or modify the lighting mode.
Proceed as follows to make these settings:
- press the button
- use the
- press the key to confirm
- use the
- press the key to change the setting:
LEd oFF to disable the lighting device
or LEd 1 to activate the lighting device when acquiring
ALU1 P or ALU2 P balancing programme, at the end of a spin cycle in the
case of residual unbalances for 30 seconds, in CP (centred position) for an
additional 30 seconds
or LEd 2 in this configuration, the light will turn on, in addition to the situations indi-
cated above (in the Led1 mode) also during the entire measurement cycle,
when acquiring dimensions in all balancing programmes and in the Hidden
Weight programme when selecting the two planes behind the spokes.
- press the key to confirm and exit.
15.13. SET UP - LASER INDICATOR
The machine allows the operator to enable or disable the laser device.
Proceed as follows to make this setting:
- press the key
EM 9250 - EM 9250 C CompactLine Operator's manual
to confirm and exit.
keys to search for SEt UP
keys to search for LEd 1 (LEd 2 or LEd oFF if previously set)
(IF AVAILABLE)
dimensions during an
135
UK