Corghi CompactLine EM 9250 Manuel D'utilisation page 100

Wheel release
- Press the control pedal for at least one second to release the wheel from the flange.
Centring with flanges
Removing the C hub
- Insert the C special key provided with the machine in the C hub hole
- Unscrew the C hub completely.
- Mount the flange on the shaft and lock it with the two screws (A, fig. 10b) using the CH
6 wrench.
- Lock the wheel onto the flange as usual.
C hub mounting
Proceed as follows to remount the C hub:
- Press and hold the keyboard button
and bring to the open position the pneumatic cylinder of the lock device C; The mes-
sage A52 will be displayed on the monitor.
-insert into the cylindrical protective sleeve the cotter pin supplied with the machine
(B, fig.10c)
100 EM 9250 - EM 9250 C CompactLine Operator's manual
10a
10b
for 3 seconds to lock the shaft rotates
(fig.10a);