General Configurations - Set Up - Corghi CompactLine EM 9250 Manuel D'utilisation

• press the key to display the total number of spins performed by the machine
since its first start-up (tot SPi)
• press the key to display the number of spins performed since the last sensitivity
calibration (CAL SPi). It is reset at each new calibration
• press the key to display the number of spins performed since the last sensitivity
calibration (PAr SPi). It is reset each time it is turned off
• press the key to exit.

15. GENERAL CONFIGURATIONS - SET UP

The machine can be configured according to your requirements. The following configura-
tions are available:
- Selecting vehicle type (car – motorcycle)
- Selecting the mode for acquiring wheel dimensions in the ALU1 and ALU2 balancing
programmes (ONLY the version with manual sensor)
- Unbalance unit of measurement
- Unbalance rounding-off
- Automatic search for RPA position
- Warning OPT
- Rim diameter display unit of measurement
- Rim width display unit of measurement
- Acoustic signal
- Setting - Adhesive weight application position (CLIP - LASER h6-h12)
- Display brightness setting
- LED light (if provided)
- Laser indicator (if provided)
Proceed as follows to access the configuration menu:
• press the key
• use the
• press the key.
EM 9250 - EM 9250 C CompactLine Operator's manual
keys to search for SEt UP
UK
125