Corghi CompactLine EM 9250 Manuel D'utilisation page 85

- Tape the cable to the sensor support (F, fig. 6a) so that it is never tensioned;
- Connect the sensor cable connector to the machine's rear panel (G, fig.6a).
IMPORTANT: after installing the external sensor, calibrate the sensor as described in
the paragraph "Width sensor calibration".
Assembly of the ultrasonic sensor and its "optional accessory
supplied on request" support for automatic width measurement
(Only for machines equipped with the RPA programme and wheel
- Insert the ultrasonic sensor cable inside
the slots in the metal pipe (see fig.7) fixing
the cable using the supplied hose clamp
(A, fig.7).
CAUTION
to facilitate the access of the cable in the
slots on the metal tube, it is advisable to
remove the tube from the rotation pin by
unscrewing the M12 screw present.
- Fasten the ultrasonic sensor to the guard
pipe with the three supplied screws
(Fig.7a).
- Connect the sensor cable to the connector
on the side of the casing (A, fig.7b).
- Adjust the length of the ultrasonic sensor
cable near the connector (A, fig.7b) with protection closed, to avoid deformation of the
connector during the movement of the wheel guard.
- Then lock the cable using the supplied clamp (A, fig.7). Any excess of the cable in ques-
tion must be inserted and locked (using the bases already present) inside the sensor
support. To access the sensor support, remove the plastic casing by unscrewing the four
EM 9250 - EM 9250 C CompactLine Operator's manual
6
guard)
6a
UK
7
85