Corghi CompactLine EM 9250 Manuel D'utilisation page 108

Masquer les pouces Voir aussi pour CompactLine EM 9250:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

- Keep the arms in contact with the rim until the machine has acquired the values. The
geometric data are displayed in sequence:
-A-
distance value;
-d-
diameter value;
-b-
width value.
When a geometric value is displayed, the corresponding LED illuminates on the display
panel.
- Check the values measured and then return the arm to the rest position.
- If an incorrect value has been acquired during the measurement phase, move the arms
to the rest position and then repeat the operation.
Measurements can be taken also by moving one measuring arm at a time. In this case,
sensors can be used with no preset order. Pay maximum attention to the measured data
since they are influenced by the stored ones.
After setting geometric dimensions correctly and returning the sensors to the rest posi-
tion, the unbalance values recalculated according to the new dimensions are displayed.
If the inner sensor (diameter and distance) fails to operate or
- Use the keypad to enter the wheel geometric data by following the procedure described
below:
- press the
- measure the width of the rim using the calliper provided (Fig. 12)
- modify the width value (-b-) displayed by pressing the
desired value is set.
The displayed values can be increased or decreased quickly by keeping the keys
pressed.
The width can be set in millimetres by changing the setting of the unit of measurement
in the machine's set-up menu.
108
with the inner manual sensor
button
EM 9250 - EM 9250 C CompactLine Operator's manual
keys until the

Hide quick links:

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Compactline em 9250 c

Table des Matières