Installation And Wiring; Safety Instructions; Installation Onto The Pipe - Burkert 8081 Manuel De L'utilisateur

8.

insTAllATion And WiRinG

8.1.

safety instructions

danger
Risk of injury due to high pressure
• Cut off the pressure and depressurize the pipes before loosening
the pipes and connections.
Risk of injury due electrical discharge.
• Before starting work, make sure that you switch off the supply
voltage and secure it to prevent restarting.
• Observe all applicable accident protection and safety guidelines
for electrical equipment.
16
english
Type 8081
Installationandwiring
Warning
Risk of injury due to non-conforming installation.
• The electrical and fluid installation can only be carried out by quali-
fied and skilled staff with the appropriate tools
• Install appropriate safety devices (correctly rated fuse and/or
circuit-breaker).
• Use cables with an operating temperature limit which is suitable
for your application.
• Under normal conditions of use, cables with a 0.75 mm
section should be enough to transmit the signal.
Risk of injury due to unintentional switch on of power supply or
uncontrolled restarting of the installation.
• Take appropriate measures to avoid any involuntary activation of
the installation.
• Guarantee a set or controlled restarting of the process subsequent
to the assembly of the device.
8.2.

installation onto the pipe

danger
Risk of injury due to high pressure in the installation.
• Cut off the pressure and depressurize the pipes before loosening
the pipes and connections.
cross
2