Fault; Troubleshooting; Table Of Alarm Indications; 3326460_Ut_Gb_Rev.2 - Angelo Po BX61E Manuel D'utilisation

TROUBLESHOOTING

The appliance has been tested before being put into service.
The information provided below is intended to assist in the identifi cation and correction of any
anomalies and malfunctions which might occur during use.
The user can solve some of these problems himself, but for others specifi c technical knowledge
or skill is required, and so they must only be carried out by qualifi ed staff with recognised
experience acquired in the specifi c sector of operation.
Important
For all requirements contact the agents or the headquarters of Angelo Po which can be
found in the contacts section of the website http://www.angelopo.com.

Fault

The appliance does not switch
on
Cooking cycle does not start or
stops suddenly

TABLE OF ALARM INDICATIONS

If the problem or fault noticed is not amongst those
listed in the table, consult the "Key to Alarms" table
provided below.
The information provided below s intended to iden-
tify the alarm signals which appear on the display
(11).
Important
Press button (14) to reset the alarm and the coo-
king cycle restarts automatically; if this is not the
case, press the start key (2).

3326460_ut_GB_rev.2

FAULT
Cause
Fuse "blown".
Safety or protection device (safe-
ty thermostat or overload cutout)
tripped.
Electronic circuit board damaged. Contact the after-sales service.
Control board electronic circuit
board damaged.
Alarm triggered.
11
14
- 19 -
Remedy
Replace the fuse (see installation
manual).
Press device reset button.
Contact the after-sales service.
Consult the "Key to Alarms" table.
REAL
INJ
GB
2
ENGLISH