Water Drain Connection; Electrical Connection; Caution - Warning - Angelo Po BX61E Manuel D'utilisation

WATER DRAIN CONNECTION

Important
For Australia only: The water drain connection must be in accordance with AS/NZS3500.2.
To carry out this operation, proceed as follows.
1) Connect the mains water pipe (C) to the appliance's connection pipe (A).
2) Connect the vent pipe (D) to the appliance connection pipe (C) and fi x it to the support (E).
The appliance's drain line is fi tted with the plug
(B) allowing discharge of the waste deposited.

ELECTRICAL CONNECTION

Caution - Warning

The connection must be made by authorised, skilled personnel, in accordance with the rele-
vant legal requirements, using appropriate and specifi ed materials. The appliance is supplied
with operating voltage 400V/3N/PE, which can be switched to230V/3/PE (see next point) (only
for model BX61-101-82). Before doing any work, cut off the mains electricity supply.
Connect the appliance to the mains electricity supply as follows.
1) If not already present, install an automatic circuit-
breaker (B), protecting only each single appliance
and located close to it, with the following cha-
racteristics.
– Thermal breaker device (to adjust see table on page 3
of the user instructions manual).
– Diff erential breaker set at 30 mA
– Classe B o C (IEC 898).
2) Undo the screws and remove the side panel (A).
3) Connect the automatic circuit-breaker (B) to
the appliance's terminal board (C) and to the
electrical mains supply, in accordance with the
electrical system diagram provided at the back of
the manual and using a cable with the following
characteristics.
– Weight: ≥ than H05RN-F type (designation 245 IEC 57).
– Temperature of use: ≥70°C.
Important
When connecting, take care to connect the neutral and earth lines.
4) Replace the panel and retighten the screws when the operation is complete.
3326460_GB_inst_rev.2
C
A
- 9 -
D
C
B
B
C
E
Ø17
A
ENGLISH
GB