Setting The Knife No; Setting The Cut Length; Setting The Cut-Before/Cut-After Knives - JUKI MEB-3200 Manuel D'utilisation

(1) Setting the knife No.

0 ... Decorative
buttonhole

(2) Setting the cut length

W h e n t h e c u t l e n g t h i s c h a n g e d , t h e
number of stitches of the parallel section
will automatically change.
When sewing length is lengthened in case of taper bar length, compensation at the sewing end, etc.,
the setting range of the cut length is decreased as much as the length.
Example) Cut length ＋ (plus) taper bar length ≦ 38 mm (long thread trimming)

(3) Setting the cut-before/cut-after knives

3
Cut-before
Cut-after
knife
knife
22
1
2
a
b
1 to 6 ... Eyelet
buttonhole
2
1
Length
4
2
1
Set the knife No. of the same shape as
that of the knife mounted on the sewing
machine. [See item (1) on page 26.]
Set the knife No. with [RIGHT
] key 2 .
The No. can be set 0 to 6.
No.
1
2
3
4
5
6
Set the length to be cut with the knife.
Set the length with [RIGHT
key 2 .
The length can be set in increments of 1 mm within the
range of the table below in accordance with the thread
trimming type. The figures in ( ) parentheses are in
case of taper bar or without bar tacking.
Thread trimming type
Long thread trimming
Long thread trimming
without loop thread trimming
Short thread trimming : Sewing length S
Short thread trimming : Sewing length M
Short thread trimming : Sewing length L
Short thread trimming without gimp (T)
Set whether the cut-before knife or the cut-
after knife.
1) Data of the cut-before knife can be immediately set
with [CB ] key 3 .
2) Data of the cut-after knife can be immediately set
with [CA ] key 4 .
3) The data can be set with [RIGHT
[RIGHT ] key 2 as well.
When setting the data
without knife, set the
value to "0".
Set value can be set
"0" to 2.
] key 1 or [RIGHT
a × b
2.1 × 3.2
2.5 × 3.8
2.9 × 4.4
3.0 × 4.6
3.2 × 5.4
2.7 × 5.1
] key 1 or [RIGHT
Setting range
10 to 38 mm
10 to 50 mm
16 to 24 (26) mm
24 to 32 (34) mm
32 to 40 (42) mm
10 to 34 mm
] key 1 or
Set value Motion
0 Without knife
1 Cut-before knife
2 Cut-after knife
]